E-Book, Englisch, 148 Seiten
ISBN: 978-3-0357-3700-4
Verlag: Trans Tech Publications
Format: PDF
Kopierschutz: 0 - No protection
Autoren/Hrsg.
Fachgebiete
Weitere Infos & Material
Preface
Chapter 1: Properties and Processing Technologies of Structural Steel and Alloys
Simulation and Optimization of Temperature Field of Tank Cover with Super Large Diameter during the Creep Aging Forming Process
The Study on Porosity Controllable Filter Material for the Integrated Gasification Combined Cycle
Formation of Ferrosilicon Alloy at 1550°C via Carbothermic Reduction of SiO2 by Coal and Graphite: Implication for Rice Husk Ash Utilization
Effect of Cast and Heat Treatment Processes on Microstructure and Properties of K4169 Superalloy
Anisotropy in Compression Creep-Ageing Behavior of 2219-T3 Aluminum Alloy
Investigation on the Stress Relaxation Aging Behavior of 2195 Al-Li Alloy
Damping Performance of Material Candidates for Service at 350K
A Calculation Method for the Coupling of Temperature and Concentration during Inconel 718 Alloy Solidification
The Influences of Third Alloying Element on the Internal Friction Behavior and the Mechanical Properties in the Water Quenched Ti-12Mo Alloys
The Phase Constitutes of Ti-Mo-Based Alloys
Image Evaluation of Distribution of Carbide Particles in Repeatedly Quenched (Two and Three Times) JIS-SUJ2 Steels
Surface Observation of Induction-Heated 13Cr-2Ni-2Mo Stainless Steel after Interrupted Fatigue Testing under Rolling Contact Stress in Water
Examination of Dynamic Strain Ageing Effects during Rapid Quenching of Inconel 718 Superalloy Disc
Length-Scale-Dependent Micromechanical Modeling for Precipitate Hardening in Inconel 718 Superalloy
Arrangement Optimization and Crashworthiness Analysis of B-Pilla Solder Joint Based on Collision Safety
Detection of Hydrogen Damage in 2.25Cr1Mo0.25V by Ultrasonic Inspection
Some Issues of Repairing Manned Space Vehicles in Outer Space Using Electron Beam Welding
Chapter 2: Composites, Polymers and Coatings
Insights into the Self-Optimized Hydrophobicity of Cerium Oxide Surface under Impact Abrasive Wear
Thermal Properties of High Density Polyethylene/Poly(Vinyl Alcohol) Fiber Composites Prepared Using Laboratory Mixing Extruder
Research on Vibrating L-Box Test and Yield Value of Low Water-Cement Ratio Concrete
Influence of Cellulose Fiber Content on Morphology and Properties of Poly(Lactic Acid)/Propylene-Ethylene Copolymer/Cellulose Composites
