Martins / Fortunator / Ferreira Advanced Materials Forum II

Erscheinungsjahr 2004
ISBN: 978-3-0357-0627-7
Verlag: Trans Tech Publications
Format: PDF
Kopierschutz: 0 - No protection

E-Book, Englisch, 920 Seiten

The II International Materials Symposium is a scientific forum which discusses advances in the science and technology of materials, and is organized by the Portuguese Materials Society. The II International Materials Symposium followed a series of bi-annual national and international conferences that began 20 years ago and has became, since 2001, an international forum where scientists, engineers and technologists working in the fields of Materials Science and Engineering discuss their recent results and exchange ideas and information.

Autoren/Hrsg.

Martins, Rodrigo

Fortunator, Elvira

Ferreira, Isabel

Dias, Carlos

Fachgebiete

• Technische Wissenschaften Maschinenbau | Werkstoffkunde Technische Mechanik | Werkstoffkunde

Inhaltsverzeichnis

Preface
Advances in Electrochromic Materials and Devices
Physical Properties of Sputtered ITO and WO3 Thin Films
ZnO:Ga Thin Films Produced by RF Sputtering at Room Temperature: Effect of the Power Density
Effect of Thermal Treatment on the Properties of Sol-Gel Derived Al-Doped ZnO Thin Films
KrF Laser CVD of Chromium Oxide by Photodissociation of Cr(CO)6
Deposition of SiO2 and SiO2:Ge Films for Optical Applications in a Matrix Distributed Electron Cyclotron Resonance Reactor
Structural and Dielectric Characteristics of Ba2MeWO6 (Me=Mg, Ni, Zn) Double Perovskites
Microstructure and Electrical Properties of SrBi2Ta2O9 Ceramics Processed by Templated Grain Growth
Structural and Dielectric Properties of Mg-Doped Strontium Titanate Ceramics: Dependence on the Materials Processing
La(Mg1/2Ti1/2)O3 – Based Materials for Microwave Applications
Lead Zirconate Titanate Thin Films Prepared with Different Types of Seeds: A Comparison Study
The Use of Thin Silicon Films in Flat Panel Displays
Improvement of Field-Effect Mobilities in TFTs: Surface Plasma Treatments Vs Stack Dielectric Structures
Sputtering Preparation of Silicon Nitride Thin Films for Gate Dielectric Applications
MIS Photodiodes of Polymorphous Silicon Deposited at Higher Growth Rates by 27.12 MHz PECVD Discharge
Characterization of Polymorphous Silicon Thin Film and Solar Cells
Stacked a-SiC:H Optical Transducers: the Influence of the Sensing Material
Dynamic Characterization of Large Area Image Sensing Structures Based on a-SiC:H
High Sensitive Image Sensors Based on a Tandem Laser Scanned Photodiode
Effect of Annealing on Gold Rectifying Contacts in Amorphous Silicon
Composition, Structure and Optical Characteristics of Polymorphous Silicon Films Deposited by PECVD at 27.12 MHz
Batch Processing Method to Deposit a-Si:H Films by PECVD
Influence of the Rapid Thermal Annealing on the Properties of Thin a-Si Films
Role of Substrate on the Growth Process of Polycrystalline Silicon Thin Films by Low-Pressure Chemical Vapour Deposition
Spiral Inductors on Silicon for Wireless Communications
Silicon Etching in CF4/O2 and SF6 Atmospheres
Optimisation of a Home-Made RIE System - Effect of SF6 Plasma on the Properties of Partially Etched a-Si:H Films
Optical and Morphological Properties of Annealed PbS Thin Films Obtained from a Chemical Solution.
Absolute Scale Reciprocal Space Mapping on X-Ray Diffractometers Incorporating a Position Sensitive Detector: Application to III-Nitride Semiconductors
Recent Advances in Spintronics. Half-Metal Ferromagnets: Their Role in Spintronics
An Approach to the Magnetic Disaccommodation in Nd Doped Yttrium Iron Garnets
Magnetocaloric Effect in Manganites: Ferromagnetism and Charge-Ordering Effects
Study of Giant Magnetoimpedance in Amorphous Wires by Means of the Complex Impedance Phase Analysis
Donor/Acceptor Substituted Oligothiophenes: Synthesis, Spectroscopic and Electrochemical Properties
Structure of Cellular Cordierite Foams
Aqueous Tape Casting of Low-k Cordierite Substrate: The Influence of Glass Content
Crushing Behaviour of Cellular Cordierite Foams
Fabrication of Cellular Cordierite Foams
Thermal Expansion Behaviour of P2O5-Doped Sol-Gel-Derived Cordierite
Synthesis and Characterization of SrBi2Nb2O9 Powders Prepared by a New Chemical Method
Combustion Synthesis Ternary Carbide Ti2AlC1-x Powders
Characterization of Glassy Phase at the Surface of Alumina Ceramics Substrate and its Effect on Laser Cutting
Thermal Cycling Life of Plasma Sprayed Alumina Coating on Cast Irons
Effect of Nitrogen Pressure and Additives on Combustion Synthesis of Rod-Like Yttrium a-SiAlON Crystals
Effect of Magnetic Field on the Crystallization Behaviour of Fe Containing Pb and Ba Borate Glasses
Crystallization of a Borosilicate Glass during Sintering Studied by Dilatometry and XRD Analysis
Effect of Different Oxide Additives on Colloidal Processing and Sintering of Alumina
The Use of Electrophoretic Deposition for the Fabrication of Ceramic Matrix Composites
Complete Densification of Si3N4 – SiC Ceramic Matrix Composites (CMC's) by a Pressureless Sintering Route
Porosity Assessment of ß-Spodumene/Glass Matrix Composites by Small Angle Neutron Scattering
Torsion of Cork under Compression
Mechanical Properties and Microstructure of Fe40Al/TiC Composites with Low Content of Intermetallic
Strengthening in a Copper Based Nanocomposite
Bentonite Clays from Paraíba State, Brazil: Effects of Na and Mg Compounds in the Rheology of the Dispersions
Recent Developments in the Powder Metallurgy Processing of Steels
Processing Effects on the Characteristics of the In-Situ Formed Al3Ni Reinforcement in a PM Al Matrix
Study of Transformations in a Cu-9Ni-6Sn Alloy by Differential Scanning Calorimetry (DSC)
Tungsten Carbide Powder Inserts in Ductile Iron
Evolution of the Recrystallization Texture in an IF Steel
Contact Fatigue Behaviour of Artificially Indented Austempered Ductile Iron Discs
Microstructural Plastic Behaviour of AISI 304 Austenitic Stainless Steel
Thermal Behaviour of Nanostructured Intermetallics Synthesized by Mechanical Alloying and Coated with Metallic Elements
Soft Annealing of High Chromium White Cast Iron
Study of Sintering Variables of Tungsten Carbide Particles Sputter-Deposited with Stainless Steel
Defects Formation in Friction Stir Welding of Aluminium Alloys
In-Phase Multiaxial Fatigue Analysis of Tubular AlMgSi Welded Specimens
Effect of the Bi Content on the Mechanical Properties of a Sn-Zn-Al-Bi Solder Alloy
Effect of Cooling Rate on the Microstructure and Hardness of Austenitic Stainless Steel Welds
Corrosion Resistance of Two Ternary Mg88Ti5Si7 and Mg60Ti10Si30 Alloys Synthesised by Mechanical Alloying
Characterization of Glassy Phase at the Surface of Alumina Ceramics Substrate and its Effect on Laser Cutting
In Situ XRD Study of the Graphite Surface Layer Formation during Thermal Cycling of Cast Iron
Cyclic Deformation Behaviour of Copper Polycrystals Pre-Strained in Tension
Microstructure and Thermo-Mechanical Properties of NiTi Shape Memory Alloys
In-Situ GIXRD Characterization of the Crystallization of Ni-Ti Sputtered Thin Films
Effect of Thermal Cycling on the Transformation Temperatures of a Ni-Ti Shape Memory Alloy
Preparation of Porous Hydroxyapatite Particles to Be Used as Drug Delivery Systems
Production of Porous Hydroxyapatite with Potential for Controlled Drug Delivery
Influence of Characteristics of the Starting Hydroxyapatite Powders and of Deagglomeration Procedure, on Rheological Behaviour of HA Suspensions
Effect of the Enzyme Concentration on the DIRECT Coagulation Casting of Hydroxyapatite-Alumina Bodies
Medical Applications of Bonelike® in Maxillofacial Surgery
Bonelike®/PLGA Hybrid Materials for Bone Regeneration: In Vivo Evaluation
Effect of Human Serum Proteins on Pure Hydroxyapatite and Silicon Substituted Hydroxyapatatite: AFM and SEM Studies
Network Connectivity and Bio-Mineralization of 0.45SiO2–(0.45-x)MgO–xK2O–0.1(3CaO:P2O5) Glasses
Synthesis and Characterization of Amorphous Silica Modified with Organic Ligands
Mechanical Characterization of Dental Restorative Composite Materials
Protein Adsorption Effect on In Vitro Acellular Biodegradation of CaO-P2O5 Glass Ceramics
Early Steps of Orthophosphate Crystallisation in a Ca-Mg-K Phosphosilicate Glass Frit
Bioinspired Macromolecular Actuators
A Piezoelectric Pseudo-Composite Polymer Film for the Detection of Proteins
Novel Bioresorbable Poly(lactide-co-glycolide) (PLGA) and PLGA/Bioglass ® Composite Tubular Foam Scaffolds for Tissue Engineering Applications
Capacitance Response of Polysiloxane Films with Interdigital Electrodes to Volatile Organic Compounds
Hydrophilic – Hydrophobic Polymers Based on Poly(L-lactide) and Poly(2-Hydroxyethyl Methacrylate)
Enzymatic Degradation of Starch Based Thermoplastic Compounds Used in Protheses
Swelling and Tribological Properties of Poly (HEMA) Hydrogels
Miscanthus x Giganteus: Contribution to a Sustainable Agriculture of a Future/Present - Oriented Biomaterial
Electrical Charge Injection/Ejection and Transport at Moderate Fields in Low-Density Polyethylene
The Influence of Water on Direct Current Conductivity of Cork
Isothermal and Non-Isothermal DC Measurements to Analyze Space Charge Behavior in Polyamide 11
Spectrophotometric and Electrokinetic Characterization of Dye Sorption on PA 6
Correlation between High Power Proton T2 NMR Relaxation and Macroscopic Viscoelastic Properties
TGA as a Tool for Studying the Thermal Stability of Polymeric Materials
Comparative Study, by Optical Techniques of the Interface Polymer/Steel in Replication Conditions
Residual Strength in Adhesive Joints with a Natural Fibber Reinforcement Interface Layer
PP/LCP Blends: Influence of the LCP Content on the Mechanical, Rheological and Morphological Properties
Effect of Experimental Conditions on the Grafting of Maleic Anhydride onto Polyethylene in Extruders
Electrochemical Synthesis of Po